Congrats on your new Lamassu Bitcoin Machine! Let's get started.
When powering off the machine, first use a single press and quick release to the tablet's power button, located inside the door.
It may be unplugged only after it's gone through the Lubuntu splash screen to a fully black screen.
Pulling the power cable, switching off electricity, or holding down the power button until it forcefully shuts down can result in data corruption and require reflashing its hard drive.
To protect the machine against unintentional power loss and incomplete shutdowns we strongly recommend using a battery backup (UPS).
Setting up your Admin
The first step is to setup the admin panel which controls your machine. You can perform this before your machine arrives. To do so, please see the section: Admin Setup (Step-by-Step).
Carefully open the crate and inspect the contents. Your machine was sent with 2 sets of Abloy keys in a small blue box, taped to the bottom of the machine. There are 2 keys for the exterior door lock, and 2 for the interior vault.
There is also a small card that provides a code for the locks used. Store this card in a safe place, and make backup copies of the information on the card. If you misplace your keys and key card you will not be able to access the machine's interior and vault.
We highly recommend that you keep the crate and all packing materials for your own transport purposes and in case servicing or repair is required during the warranty period.
Open the interior vault with the blue key, then locate and remove the blue shipping tape on either side of the cashbox. Once removed, you may withdraw the cashbox by pulling directly out on its green handle. Cash may be removed by the box by inserting a finger into the top hole of the cashbox and lifting upwards. Reinsert the cashbox by pushing it fully back in. If not properly inserted, the machine will display an error. While the machine is on, when reinserted fully, you will hear the bill validator engage.
If your machine was damaged in transit or is missing anything please email us immediately at: firstname.lastname@example.org.
Pairing with your Admin
Connect your machine to internet by connecting an Ethernet cable to the underside port of the machine. If Ethernet is not available, use a secure Wi-Fi network (the Wi-Fi selection screen will be available after the machine has initialized below). Please see "Best Practices for Connectivity" for more details.
Plug the machine into wall power. Once booted, initialize the machine by pressing the INIT button. After your admin has been configured following the steps in "Admin Setup (Step-by-Step)", take a picture of the pairing QR code from the Pairing panel within the admin, then press the Scan button on the machine and present the photo of pairing QR code to the scanning bay window.
Only place a small amount of bitcoins in the machine's wallet for testing purposes. Conduct thorough test transactions with all denominations and as many series of your local currency. If you receive consistent rejections, your bill validator may benefit from a cleaning. Should you receive consistent note rejections afterwards, please contact support as there may be a firmware update for your bill validator.
Mounting & Installation
You may securely mount your machine to a Braga or Santo Tirso stand, or a surface of your choice using the included bolts and mounting plate.
See "Phsyical security & mounting" for further details and schematics.
Launch & Marketing
We look forward to your launch! Please let us know any way in which we might assist.
Our media coordinator Kari offers a guide on gaining greater exposure for your machine. Her tips and contact info can be found in "Media Tips & Press Releases".